Powertap SLC+ User Guide User Manual download pdf (Page 8)

System Overview cont.

COMPATABILITY

The PowerTap hub is compatible with Shimano 8, 9, and 10 speed systems or Campagnolo 8,

9, and 10 speed systems. Freehub bodies may be interchanged. Reference FREEHUB

REPLACEMENT for further instructions.

The PowerTap is available in 130mm (Road) and 135mm (MTB) axle lengths. Only insert the

correctly spaced PowerTap hub into your frame. For example, only use a 130mm-spaced hub

in a 130mm road frame. Do not force the hub into any frame. Doing so may cause failure of

the frame, hub, or both, and will void the warranty. Contact your dealer or Saris Cycling Group

to address any special compatibility concerns.

WHEEL BUILDING

Contact a wheel building professional or dealer for assistance in building the PowerTap wheel

if not purchased as a complete wheel. Due to the design of the hub, the load pattern is not

the same as a conventional hub. Slotting the hub flanges to accommodate bladed spokes is

not recommended and will void the warranty. Complete wheel building hub dimensions are

listed in TABLE 2.

Reference a spoke-length calculator to determine proper spoke length.

TABLE 2 - MTB Wheel Building Dimensions

IMPORTANT:

For your safety, the non-drive side of the PowerTap hub must be built with at least a 2x

lacing pattern. Because of the patented PowerTap design, torque is transferred through

the hub to the non-drive side. Failure to adhere to this precaution will void the warranty.

TABLE 3 - Road Wheel Building Dimensions

Measurements Drive Non-Drive

SL+, SLC+, wheel center

to flange

15.9mm 33.9mm

Elite+, Pro+, (or any

PowerTap with 12 mm axle)

wheel center to flange

17.4mm 32.4mm

Flange Diameter 70mm 70mm

Spoke Hole Diameter: 2.5

Measurements Drive Non-Drive

12 mm Axle 19.9mm 29.9mm

15 mm Axle (SL+) TBD TBD

Flange Diameter 74mm 74mm

Spoke Hole Diameter: 2.5

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

No comments

Powertap SLC+ User Guide User Manual Page 8